Kereső
Bejelentkezés
Kapcsolat
2,5D-s trochoidális stratégiák hatásai a forgácsolási folyamatra |
Tartalom: | http://real.mtak.hu/169976/ |
---|---|
Archívum: | REAL |
Gyűjtemény: |
Status = Published
Subject = T Technology / alkalmazott, műszaki tudományok: T2 Technology (General) / műszaki tudományok általában Type = Article |
Cím: |
2,5D-s trochoidális stratégiák hatásai a forgácsolási folyamatra
|
Létrehozó: |
Kónya, Gábor
Kovács, Zsolt Ferenc
Sándor, Roland
|
Dátum: |
2023
|
Téma: |
T2 Technology (General) / műszaki tudományok általában
|
Tartalmi leírás: |
Jelen publikációban a szerzők a 2,5D-s trochoidális
szerszámpályák hatásait mutatják be Al7075-ös anyagminőségű
alumínium nyitott horonymarása esetén, mellyel céljuk
összehasonlítani a kutatás során alkalmazott stratégiákat. Ezzel
azt vizsgálták, hogy az adott körülmények között melyik
eredményezi a lehető legkisebb szerszámterhelést, ezzel
növelve a szerszám éltartamát, illetve ezzel párhuzamosan a
lehető legjobb felületi minőséget. Az egyes stratégiák
jellemzésére az egységnyi méretű horonyhoz szükséges
megmunkálási időkkel, a használatukkor fellépő forgácsoló
erőkkel és nyomatékkal, a hornyok talpfelületén mért érdességi
értékekkel és a horony oldalfalán mért P-profillal (mellyel a
csipkésedést lehet jellemezni) kerültek kiértékelésre. |
In this paper, the authors present the effects of 2.5D trochoidal
toolpaths for open slot milling of Al7075 aluminium, with the aim
of comparing the strategies used in this research. In doing so,
they investigated which one results in the lowest possible tool
load under the given conditions, thus increasing the tool life and
at the same time the best possible surface quality. To
characterise each strategy, the machining times required for a
slot of unit size, the cutting forces and torque at which they were
used, the roughness values measured on the bottom of the slots
and the P-profile (used to characterise the clipping) measured on
the slot sidewall were evaluated.
|
Nyelv: |
magyar
|
Típus: |
Article
PeerReviewed
info:eu-repo/semantics/article
|
Formátum: |
text
|
Azonosító: |
Kónya, Gábor and Kovács, Zsolt Ferenc and Sándor, Roland (2023) 2,5D-s trochoidális stratégiák hatásai a forgácsolási folyamatra. GRADUS, 10 (1). ISSN 2064-8014
|
Kapcsolat: |
MTMT:33805919 10.47833/2023.1.ENG.011
|